Many of the cheeses I have made involve adding two cultures, Swiss and Jarlsberg, Manchego, to name a few, however, I haven’t made many that require 2 mesophilic cultures. I started reading Mastering Artisan Cheesemaking some time ago and I am fascinated by many of the recipes.  Most recipes are more about technique than about the name on the cheese.

Today I made “same temperature, light brine, washed cheese” p260, it most closely resembles Havarti or St. Paulin.

cheese fresh from the brine.
cheese fresh from the brine.

The creamery also created a name for the cheese they were making, Takelma after native Americans close to where they make cheese.

This was also a chance to try out my new cheese mold that has a built in cheesecloth. I ordered the new mold from Amazon using Christmas cash.

Mold with follower and attached cheese cloth.
Mold with follower and attached cheese cloth.

I love it when Christmas extends all the way to April. The mold is super sturdy, easy to use, easy to clean. Wish I had a couple.

Ingredients:

  • 2 Gallons Whole milk
  • 1/8 tsp. MM100 Mesophilic
  • 1/16 tsp. C61 Mesophilic (Called for LM)
  • 1/4 tsp. rennet
  • 1/2 tsp. Calcium Chloride

Directions:

cheese curds in the mold
cheese curds in the mold
  • Heat milk to 79°  – mix in cultures, let sit for 5 minutes,
  • Stir for 2 minutes – Up and down motion, not stirring motion. (PH was 6.34)
  • Continue to Heat to 89°
  • Stir in Calcium Chloride for 1 minute – let rest for 5 before proceeding
  • Add Rennet for 1 minute, goal time is 45 minutes
  • wait for clean break, cut 1/4inch cubes slowly…over 20 minutes
  • Let rest for 15mins.
  • Heat 1 gallon of water to 89°  –
  • Drain off 1 gallon of whey, slowly add water and 1 teaspoon of salt while stirring
  • Stir and heat to 100°  –  over a 30 minute period
  • Press under whey for 10-15 minutes ( I put a plate on top of the curd and placed a half filled milk jug on top)
  • Drain whey and place into mold – pressed with 4 lbs for 15 mins.(Probably should have been 2 lbs.)
  • Flip curd for 30 and double the weight
  • Flip for an hour, flip for 8 hours
  • Brine for 2-3 hours per pound( I went for 4 hours total)
  • Pat dry and put in frig.
  • 2-3 months aging. Can be washed or waxed.

Note: When I began to age this cheese, I placed it into the wine frig and wiped it daily with a brine solution. After just a few days the top started to look dry and cracked, so I flipped it washed it in brine. Then the other side started to look the same, until I placed it in tupperware and the cheese is looking great.  I also put 4 drops of Annatto into a cup and half of brine and used it to wipe down the cheese daily.  It is aging as well as anything I have had in the frig. Higher humidity may be the answer, but if you can’t keep up the humidity, tupperware is the answer.

Annatto Brine rub
Annatto Brine rub

How useful was this post?

Click on a star to rate it!

Average rating 0 / 5. Vote count: 0

No votes so far! Be the first to rate this post.